All the operations described in this section are done in Table mode using the table mode tool described in The Table Mode and repeated below for reference.

1

Mode Switch button.  Left click to switch to the indicated mode.  Right click to change the destination.

See Changing Modes.

2

Loads the current chord in the chord table into the big keyboard.

3

4

Turns sound ON/OFF.  See Turning Sound On and Off.

5

Displays the chord name of the chord in the keyboard.  If the state of the keyboard is not a "known" chord, then displays blank.

6

Deletes the current chord in the chord table.

7

Clears the big keyboard.

8

Inverts the current chord left or right.  see Chord Inversion.  Depending on preference settings the current chord in the chord table, or just the chord in the big keyboard is inverted.

9

Optimizes the current chord in the chord table, see Chord Optimization.

10

When visible (not fuzzy) does an undo of the last operation.

11

Enters a comment or a lyric for the current chord, see Chord Comment.

12

Transpose "to" key, see Chord Transposition.

13

Sets the signature key of the a selected range of chords, see Chord Signature Key.

14

Used for tagging a range of Chords, see Selecting a Range of Chords.

15

When sound is turned ON, plays, sequentially, the song's chords, see Playing Songs.

Alternates between playing all notes of a chord simultaneously and playing them as an arpeggio.

16

Shows the big keyboard chord in open or close voice, see Chord Voice.

17

Changes the octave position of the current chord up or down, see Chord Octave Position.

16

Advance, rewind, go to the top or to the bottom of the chord table.

19

Add the big keyboard chord at the end of the chord table.

insert the keyboard chord before the current chord.

copy, replace the current chord with the contents of the big keyboard.